c - Switch case weird scoping

Question

Reviewing some 3rd party C code I came across something like:

switch (state) {
case 0: 
    if (c=='A') { // open brace
        // code...
    break; // brace not closed!
case 1:
    // code...
    break;
    } // close brace!
case 2:
    // code...
    break;
}

Which in the code I was reviewing appeared to be just a typo but I was surprised that it compiled with out error.

Why is this valid C?
What is the effect on the execution of this code compared to closing the brace at the expected place?
Is there any case where this could be of use?

Edit: In the example I looked at all breaks were present (as above) - but answer could also include behaviour if break absent in case 0 or 1.

Answer 1

Not only is it valid, similar structure has been used in real code, e.g., Duff's Device, which is an unrolled loop for copying a buffer:

send(to, from, count)
register short *to, *from;
register count;
{
        register n = (count + 7) / 8;
        switch(count % 8) {
        case 0: do {    *to = *from++;
        case 7:         *to = *from++;
        case 6:         *to = *from++;
        case 5:         *to = *from++;
        case 4:         *to = *from++;
        case 3:         *to = *from++;
        case 2:         *to = *from++;
        case 1:         *to = *from++;
                } while(--n > 0);
        }
}

Since a switch statement really just computes an address and jumps to it, it's easy to see why it can overlap with other control structures; the lines within other control structures have addresses that can be jump targets, too!

In the case you presented, imagine if there were no switch or breaks in your code. When you've finished executing the then portion of a if statement, you just keep going, so you'd fall through into the case 2:. Now, since you have the switch and break, it matters what break can break out of. According to the MSDN page, “The C break statement”,

The break statement terminates the execution of the nearest enclosing do, for, switch, or while statement in which it appears. Control passes to the statement that follows the terminated statement.

Since the nearest enclosing do, for, switch, or while statement is your switch (notice that if is not included in that list), then if you're inside the then block, you transfer to the outside of the switch statement. What's a bit more interesting, though, is what happens if you enter case 0, but c == 'A' is false. Then the if transfers control to just after the closing brace of the then block, and you start executing the code in case?2.