开源软件名称（OpenSource Name）：

开源软件地址(OpenSource Url)：

开源编程语言(OpenSource Language)：

开源软件介绍(OpenSource Introduction)：

Container Linux Update Operator

Container Linux Update Operator is a node reboot controller for Kubernetes running Container Linux images. When a reboot is needed after updating the system via update_engine, the operator will drain the node before rebooting it.

Container Linux Update Operator fulfills the same purpose as locksmith, but has better integration with Kubernetes by explicitly marking a node as unschedulable and deleting pods on the node before rebooting.

Design

Original proposal

Container Linux Update Operator is divided into two parts: update-operator and update-agent.

update-agent runs as a DaemonSet on each node, waiting for a UPDATE_STATUS_UPDATED_NEED_REBOOT signal via D-Bus from update_engine. It will indicate via node annotations that it needs a reboot.

update-operator runs as a Deployment, watching changes to node annotations and reboots the nodes as needed. It coordinates the reboots of multiple nodes in the cluster, ensuring that not too many are rebooting at once.

Currently, update-operator only reboots one node at a time.

Requirements

• A Kubernetes cluster (>= 1.6) running on Container Linux
• The update-engine.service systemd unit on each machine should be unmasked, enabled and started in systemd
• The locksmithd.service systemd unit on each machine should be masked and stopped in systemd

To unmask a service, run systemctl unmask <name>. To enable a service, run systemctl enable <name>. To start/stop a service, run systemctl start <name> or systemctl stop <name> respectively.

Usage

Create the update-operator deployment and update-agent daemonset.

kubectl apply -f examples/deploy -R

Test

To test that it is working, you can SSH to a node and trigger an update check by running update_engine_client -check_for_update or simulate a reboot is needed by running locksmithctl send-need-reboot.