开源软件名称（OpenSource Name）：

开源软件地址(OpenSource Url)：

开源编程语言(OpenSource Language)：

开源软件介绍(OpenSource Introduction)：

MCsniperGO

This project was made possible by my donators

Installation

Windows

• Download the latest EXE from releases
• Make a folder for sniping, move the exe into that folder
• Run the exe by double clicking (windows defender may popup, that's normal)
• Open accounts.txt and ADD YOUR ACCOUNTS according to the FORMAT HERE
• Run the sniper by double clicking
• Enter the dropping username you want to snipe and your offset
• Wait for the drop! good luck.

Linux

this guide is very brief and assumes knowledge of linux

• wget the binary link (wget https://github-releases-url-here) found in releases
• Run chmod +x ./binary_name_here
• Run ./binary_name_here
• Open accounts.txt (nano accounts.txt) and add your accounts according the the format below
• Run ./binary_name_here. Note: you need to leave the terminal session open for the sniper to keep running, use tmux, ./binary_name_here, and then <Ctrl>-<B> <D> to run in tmux terminal session.
• Wait for the drop! good luck.

Mac

Download the mac binary, and then follow the Linux settings (ignore the wget step) using terminal. Make sure your terminal is in the same folder as the binary you downloaded.

Compiling from source (not recommended)

Install git and go 1.17 or later.

git clone https://github.com/Kqzz/MCsniperGO
cd MCsniperGO
go run .

Accounts file format

You have to put accounts in accounts.txt before sniping, so follow the format shown below to add your accounts

in the code block shown below, replace any words fully capitalized with actual values, just leave the other words as is.

# You can comment out lines by including a # at the start
# !! IMPORTANT !! ONLY REPLACE THE CAPITALIZED WORDS WITH THE CORRECT VALUE, EVERYTHING ELSE IS A "FLAG" FOR THE SNIPER TO KNOW WHAT TO DO WITH THE ACCOUNT.
# for example, for a prename snipe with manual bearer, do BEARERHERE:bearer:prename and DO NOT REPLACE "bearer" or "prename" with anything.

# MOJANG ACCOUNT

EMAIL:PASS:mj
# OR (if you have security questions)
EMAIL:PASS:ANSWER:ANSWER:ANSWER:mj

# Microsoft account
# THIS WILL PROMPT YOU TO LOGIN WHEN AUTHENTICATING, FOLLOW THE INSTRUCTIONS DISPLAYED WHEN YOU ARE PROMPTED.
# there is no password input. it will always be shown as 'oauth2-external' when printing a password.
IDENTIFYING_TEXT:ms
# OR FOR PRENAME
IDENTIFYING_TEXT:prename

EMAIL:PASS
# OR FOR PRENAME
EMAIL:PASS:prename

# Manual bearer
BEARERHERE:bearer

# You can add :prename for a prename snipe w/ manual bearer
BEARERHERE:bearer:prename