Welcome to OStack Knowledge Sharing Community for programmer and developer-Open, Learning and Share
Welcome To Ask or Share your Answers For Others

Categories

0 votes
1.1k views
in Technique[技术] by (71.8m points)

assembly - What are SP (stack) and LR in ARM?

I am reading definitions over and over again and I still not getting what are SP and LR in ARM? I understand PC (it shows next instruction's address), SP and LR probably are similar, but I just don't get what it is. Could you please help me?

edit: if you could explain it with examples, it would be superb.

edit: finally figured out what LR is for, still not getting what SP is for.

See Question&Answers more detail:os

与恶龙缠斗过久,自身亦成为恶龙;凝视深渊过久,深渊将回以凝视…
Welcome To Ask or Share your Answers For Others

1 Answer

0 votes
by (71.8m points)

LR is link register used to hold the return address for a function call.

SP is stack pointer. The stack is generally used to hold "automatic" variables and context/parameters across function calls. Conceptually you can think of the "stack" as a place where you "pile" your data. You keep "stacking" one piece of data over the other and the stack pointer tells you how "high" your "stack" of data is. You can remove data from the "top" of the "stack" and make it shorter.

From the ARM architecture reference:

SP, the Stack Pointer

Register R13 is used as a pointer to the active stack.

In Thumb code, most instructions cannot access SP. The only instructions that can access SP are those designed to use SP as a stack pointer. The use of SP for any purpose other than as a stack pointer is deprecated. Note Using SP for any purpose other than as a stack pointer is likely to break the requirements of operating systems, debuggers, and other software systems, causing them to malfunction.

LR, the Link Register

Register R14 is used to store the return address from a subroutine. At other times, LR can be used for other purposes.

When a BL or BLX instruction performs a subroutine call, LR is set to the subroutine return address. To perform a subroutine return, copy LR back to the program counter. This is typically done in one of two ways, after entering the subroutine with a BL or BLX instruction:

? Return with a BX LR instruction.

? On subroutine entry, store LR to the stack with an instruction of the form: PUSH {,LR} and use a matching instruction to return: POP {,PC} ...

This link gives an example of a trivial subroutine.

Here is an example of how registers are saved on the stack prior to a call and then popped back to restore their content.


与恶龙缠斗过久,自身亦成为恶龙;凝视深渊过久,深渊将回以凝视…
Welcome to OStack Knowledge Sharing Community for programmer and developer-Open, Learning and Share
Click Here to Ask a Question

...